INOX 0.65 mm cutting disc

Minimal burr and heat formation in thin material

The INOX 0.65 mm cutting disc allows faster and cooler cuts with fewer burrs than ever before. This extremely thin cutting disc is fully hardened throughout due to the patented manufacturing process. This prevents premature wear on the cutting disc. The unique manufacturing process enables maximum aggressiveness (without running off centre) as the disc does not have a hard cutting edge. Optimised for use on thin sheet metal and profiles.

Application area:

Advantages:

Speed

Maximum disc aggressiveness - penetrates the material immediately with no drifting due to lack of hard cutting edge

Extremely thin disc - easy cutting with no burrs or discolouration

Safety

Extremely resilient - oSa safety directives

Rough lateral surfaces - disc does not jam at deep immersion depths

Fibreglass reinforcement - extremely durable

Convenience

Patented manufacturing process - disc penetrates the material immediately under no pressure

Lower contact pressure required to cut through the material - less vibration and noise

Precise, chatter-free and burr-free cuts from the start - less rework required

Service life

Patented production process - disc is fully hardened to eliminate premature wear

Wear-resistant binding system - excellent service life on thin sheet metals and profiles

Straight design - deeper immersion depths and more cuts than depressed centre versions

Advice: